Heat treatment and properties of nitrogen alloyed, martensitic, corrosion-resistant steels

Reinhold Schneider, Klaus Sammt, Roland Rabitsch, Michael Haspel

Publikation: Beitrag in FachzeitschriftArtikelBegutachtung

6 Zitate (Scopus)


This paper gives a short introduction to the typical process route and material properties of these steels in comparison to standard martensitic corrosion-resistant steels. The typical response of these steels to various heat treatment parameters is shown and explained using the three grades M333, N360 and M340 (all made by Bohler Edelstahl GmbH) as examples, and the physical metallurgy of these steels and its consequences for practical heat treatment is explained. The correlation between tempering parameters and their effect on the toughness and corrosion properties is explained in particular detail, showing that these new steels not only offer far better property combinations under the usual heat treatment parameters than standard martensitic corrosion-resistant steels, but that they also open the door to extending heat treatment combinations and properties.

Seiten (von - bis)582-587
FachzeitschriftCailiao Rechuli Xuebao/Transactions of Materials and Heat Treatment
PublikationsstatusVeröffentlicht - Okt. 2004


Untersuchen Sie die Forschungsthemen von „Heat treatment and properties of nitrogen alloyed, martensitic, corrosion-resistant steels“. Zusammen bilden sie einen einzigartigen Fingerprint.