Abstract
Usually there is a discharger under the hopper at the bottom of a silo (e.g.
discharge belt, discharge screw). It must be able to bear the load of the
bulk material and should achieve the intended interaction with the hopper
for optimum draw-down.
Immediately after filling the empty hopper, the vertical pressure in the
outlet opening is usually higher than in the emptying state. For a
discharger this situation represents the critical load.
Subject of this paper is the determination of loads and drive powers of a
belt discharger test stand. The results of recognized analytical models,
simulation results and measurement results are compared. In particular,
the influence of the outlet height on the drive power will be analysed.
Titel in Übersetzung | Drive power of a discharge belt |
---|---|
Originalsprache | Deutsch |
Publikationsstatus | Veröffentlicht - 2015 |
Veranstaltung | Material Handling Constructuion and Logistics - Wien, Österreich Dauer: 15 Sep. 2015 → 16 Sep. 2015 |
Konferenz
Konferenz | Material Handling Constructuion and Logistics |
---|---|
Land/Gebiet | Österreich |
Ort | Wien |
Zeitraum | 15.09.2015 → 16.09.2015 |
Schlagwörter
- discharge belt conveyor
- drive power calculation
- filling state